The camera mount provides a variety of holes and slots for universal vehicle compatibility. Place the camera mount against your vehicle, and align the holes in the mount with the license plate mounting holes in your vehicle.Remove the rear license plate and license plate holder from your vehicle, and retain the license plate screws to install the camera mount.Vehicle Mount Installation for Europe Installing the Mount on Your Vehicle You must fasten the mount and license plate to the vehicle using at least two license plate screws, whether or not you attach the mounting tape. NOTE: The mounting tape does not replace the license plate screws. You can stack two layers of mounting tape if one layer is not thick enough to stick to your vehicle. This helps reduce camera vibration, especially if your vehicle does not provide mounting holes at the bottom of the license plate. The mounting tape secures the back of the mounting bracket to your vehicle using double-sided adhesive. Apply one or two layers of the included adhesive mounting tape to the back of the flat mounting bracket, near the bottom (optional).Insert the two camera clip screws into the holes labeled.Rotate the camera clip 180 degrees, so the Garmin logo is facing right-side-up.Using a Phillips screwdriver, fully loosen the two camera clip screws, and remove the camera clip from the metal bracket.This allows you to properly adjust the camera angle. When installing the camera at the bottom of your license plate, you must remove, rotate, and reattach the camera clip. Out of the box, the camera mount is assembled for installing the camera at the top of your license plate. To allow for proper camera angle adjustment, the Garmin® logo on the camera clip must be right-side up when the mount is installed on your vehicle. Installing the Camera at the Bottom of Your License Plate Install license plate screws through the bottom holes of the license plate, and tighten (optional).This option is not available for all vehicles or for all mounting bracket positions.Fully tighten the license plate screws.Insert the license plate screws through the top of the license plate and mount, and into the license plate mounting holes on your vehicle.It is your responsibility to follow license plate mounting regulations. Some jurisdictions prohibit covering any portion of the license plate. You must avoid covering any text or numbers on the license plate. You should use the mounting position that fits your vehicle and covers the smallest portion of the license plate. Hold the license plate and mount up to the license plate area on your vehicle, and slide the mount up or down to align one set of mounting holes with the holes in the license plate.If there is not enough room above the license plate on your vehicle, you can configure the mount for installation below the license plate (Installing the Camera at the Bottom of Your License Plate, page 1). NOTE: It is recommended to install the camera above the license plate, if possible. The flat metal plate on the bracket slides behind the license plate. Slide the metal bracket over the top or bottom of the license plate. NOTE: The camera mount is intended to be installed onto the bare license plate, and it is not compatible with vanity frames or license plate covers.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |